Command List - Sony PDW-510P Operation Manual

Note
If you power this unit off during an FTP connection,
the data transferred thus far is discarded.

6-3-2 Command List

This unit supports standard protocol (see the next section),
and extended protocol (see page 111).
Notes
• To execute FTP commands, you must install application
software such as PDZ-1 on your computer.
Standard commands
The following table shows the standard FTP commands
supported by this unit.
Command name Description
USER Send this command to begin the login
process.
PASS After sending the USER command,
send this command to complete the
login process.
QUIT Terminates the FTP connection. If a file
is being transferred, terminates after
completion of the transfer.
PORT Specifies the IP address and port to
which this unit should connect for the
next file transfer (for data transfer from
this unit).
PASV This command requests this unit to
"listen" on a data port (which is not its
default data port). It puts this unit into
passive mode, waiting for the remote
computer to make a data connection.
To log out
To log out after finishing file operations, enter "QUIT" at
the command prompt and press the Enter key.
• The commands supported by application software vary.
• An FTP client that supports UTF-8 is required to use
Unicode characters other than ASCII characters.
Command prompt FTP commands do not support
UTF-8.
In the command syntax column, <SP> means a space,
entered by pressing the space bar, and <CRLF> means a
new line, entered by pressing the Enter key.
Command syntax
USER <SP> <username> <CRLF>
Input example: USER admin
PASS <SP> <password> <CRLF>
Input example: PASS pdw-530 (or 510)
QUIT <CRLF>
PORT <SP> <h1,h2,h3,h4,p1,p2> <CRLF>
• h1 (most significant byte) to h4 (least significant byte): IP
address
• p1 (most significant byte), p2 (least significant byte): Port
address
Input example: PORT 10,0,0,1,242,48
(IP address: 10.0.0.1, Port number: 62000)
PASV <CRLF>
107
6-3 FTP File Operations