Advertisement
VISCA
RS-422
1)
Commands
Use of RS-422 control software based upon this
command list may cause malfunction or damage to
hardware and software. Sony Corporation is not liable
for any such damage.
Overview of VISCA
In VISCA, the device outputting the commands, for
example, a computer, is called the controller, while the
device receiving the commands, such as this unit, is
called the peripheral device. In VISCA, up to seven
peripheral devices can be connected to one
controller using communication conforming to the
RS-422 standard. The parameters of RS-422 are as
follows.
• Communication speed: 9600 bps/38400 bps
• Data bits : 8
• Start bit : 1
• Stop bit : 1
• Non parity
Flow control using XON/XOFF and RTS/CTS, etc., is
not supported.
Note
For this camera, one controller can be connected to one
SRG-360SHE/SRG-280SHE. To connect multiple SRG-
360SHE/SRG-280SHE devices, use VISCA over IP. For the
use of VISCA over IP, refer to "VISCA over IP" (page 22).
..............................................................................................................................................................................................................................
VISCA is a protocol developed by Sony for controlling a consumer's camcorder. "VISCA" is a trademark of Sony
1)
Corporation.
Command List
1
Advertisement
