Sony PDW-510P Operation Manual page 201

No. Page Item
16 GENLOCK GENLOCK
RETURN VIDEO
GL H PHASE
GL SC PHASE
GL SC 0/180 SEL
17 ND COMP ND OFFSET
(PDW-530/530P ADJUST
only)
CLEAR ND
OFFSET
18 AUTO SHADING AUTO BLK
SHADING
RESET BLK SHD
TEST OUT SELECT ENC/R/G/B
MASTER GAIN
(TMP)
19 DISC DELETE LAST CLIP EXEC
DELETE ALL CLIPS EXEC
QUICK FORMAT
20 NETWORK DHCP
IP ADDRESS
SUBNET MASK
DEF. GATEWAY
LINK SPEED
DUPLEX
1) The setting of this item is overridden by the setting of BEFORE END 3
when TYPE DETECTION in the BATTERY 2 page is set to OTHER.
2) The setting of this item is overridden by the setting of END 3 when TYPE
DETECTION in the BATTERY 2 page is set to OTHER.
3) This is supported from firmware version 1.4.
4) When TYPE DETECTION in the BATTERY 2 page is set to AUTO, any
batteries other than Sony BP-series batteries and Anton Bauer intelligent
battery systems are classified as "Others".
5) Flashes once per second when the battery status is "BEFORE END", and
flashes 4 times per second when the battery status is "END".
6) This is supported from firmware version 1.5
Settings Default
OFF/ON ON
OFF/ON OFF
(–60 to +139) 0
(PDW-510/530)
(–59 to +142) 0
(PDW-510P/530P)
(–99 to +99) 0
0/180 180
OFF/ON —
— EXEC
EXEC EXEC
EXEC EXEC
ENC
–3/0/3/6/9/12/18/ 0 dB
24/30/36/42/48 dB
EXEC
EXEC
EXEC EXEC
ENABL/DSABL DSABL
xxx.xxx.xxx.xxx 192.168.1
.10
xxx.xxx.xxx.xxx 255.255.2
55.0
xxx.xxx.xxx.xxx 0.0.0.0
AUTO/10 Mbps/ AUTO
100 Mbps
AUTO/FULL/HALF AUTO
Description
Turns genlock on and off.
Turns return video on and off.
Genlock H phase setting.
Genlock subcarrier phase setting
Genlock subcarrier phase setting
Turns on and off the mode which sets ND
(neutral density) filter color compensation
values.
Clears ND filter color compensation values.
Execute the auto black shooting function.
Clears black shooting compensation values.
Selects the signal output to the TEST OUT
connector.
Temporarily sets the master gain value.
Delete the last clip.
Delete all clips on the disc.
Formats the disc. All the recorded data is
deleted.
Selects whether to enable automatic
acquisition of the IP address from a DHCP
server.
Sets the IP address.
Sets the subnet mask.
Sets the default gateway.
Sets the communications speed.
Sets the duplex mode.
201
Menu List