File Access Mode File Operations - Sony PDW-510P Operation Manual

• Deletion and renaming of directories
Notes
• File names and directory names can use letters, numbers,
and symbols from the Unicode 2.0 character set.
However, the following control characters and symbols
cannot be used.
- Control characters: U+0000 to U+001F, U+007F
- Symbols: ", *, /, :, <, >, ?, \, |
1) This is supported from firmware version 1.4. However, the following
character codes cannot be used by FAM connections.
U+010000, U+020000, U+030000, U+040000, U+050000,
U+060000, U+070000, U+080000, U+090000, U+0A0000,
U+0B0000, U+0C0000, U+0D0000, U+0E0000, U+0F0000,
U+100000
(There are no limits to characters which can be used by FTP
connections.)
6-2 File Access Mode
File Operations
1)
File access mode operating environment
Operating system requirements for file operations by file
access mode (called FAM below) are as follows.
• Computer operating system: Microsoft Windows 2000
Service Pack 4 or higher, or Microsoft Windows XP
Preparations
Do the following on the remote computer and this unit.
• Install the FAM driver on the remote computer.
• Enable FAM connections over the i.LINK connector.
To install the FAM driver
Insert the supplied CD-ROM (Proxy Browsing Software
PDZ-1) in the CD-ROM drive of the computer and execute
the Setup.exe file, then follow the installation instructions.
For details, refer to the ReadMe file contained on the CD-
ROM disc.
Note
Use Version 1.4 or higher of the FAM driver. The FAM
driver on the supplied CD-ROM is Version 1.4 or higher.
If a FAM driver is already installed on your computer,
check the version.
To check the version, click "Add or Remove
Programs"(Windows XP) or "Add/Remove Programs"
(Windows 2000), select "ProDisc," and then click "Click
here for support information."
To enable FAM connections over the i.LINK
connector
Proceed as follows.
1
Set the MENU ON/OFF switch to ON.
The last accessed page appears.
2
Turn the MENU knob to scroll to the OUTPUT page,
then press the MENU knob.
The OUTPUT page appears. The current settings
appear on the right side of each item.
3
Move the b mark to "i.LINK MODE", then press the
MENU knob.
The b mark changes to a z mark, and the z mark
changes to a ? mark.

6-2 File Access Mode File Operations

103