InMotion R2 Manual page 15

Assembling the INMOTION SCV:
1. Insert the Handlebar into the top of the Turning Shaft (the slimmer part), and tighten the Screw using the Installation Tool.
The extra Screw and Installation Tool are included in the box. Please pay attention to the front and back of the Handlebar.
2. Unlock the Quick Release Lock, insert the Turning Shaft into the Pivot Base Assembly until you feel resistance, and lock
the Quick Release Lock. Please note, if the Turning Shaft is not completely inserted, the Quick Release Lock cannot be locked
properly. Assembly of the Turning Shaft is now complete. When necessary, remove the Turning Shaft from the SCV by unlocking
the Quick Release Lock.
3. Remove the Battery Pack from the battery package, lean the INMOTION SCV body forward, and hold it steady. Push the
Battery Pack into the Battery Slot. When you hear a "Da" sound, gently try to pull the Battery Pack out. The Battery Pack is
installed properly if it cannot be removed without releasing the latch (If battery has already installed on the SCV, please skip this
process).
4. Press the Reset Button on the back of the SCV, then front light and tail light simultaneously lights on for a second, then
lights off. This means that the SCV has been activated. Hold the SCV parallel to the ground, after a sound, you can turn on the car，
Now hold INMOTION SCV at upright position with the Footboard parallel to the ground, and press the power on button.
 If necessary, especially when you need to put the INMOTION SCV inside small spaces, such asbacktrunk of your car,
the Turning Shaft and the Handlebar can be quickly removed by unlocking the Quick Release Lock.
storage and transportation for INMOTION SCVbase on actual situation flexibly .
15 / 64
Please choose the