H3C S9500 Series Command Manual page 152

Command Manual – VLAN
H3C S9500 Series Routing Switches
1.3.2 display protocol-vlan vlan
Syntax
display protocol-vlan vlan { vlan-list | all }
View
Any view
Parameters
vlan-list: VLAN list. You can specify a VLAN in the list by its ID. Alternatively, you can
specify a VLAN range in the form of vlan-id to vlan-id where the end VLAN must be
greater than the start port.
all: Specifies to display protocol information of all VLANs.
Description
Use the display protocol-vlan vlan command to display the protocols and protocol
indexes configured in the specified VLAN(s) or all VLANs.
Examples
# Display the protocols and protocol indexes configured in VLAN 522.
<H3C> display protocol-vlan vlan 522
VLAN ID: 522
VLAN Type: Protocol-based VLAN
Index
0
1
2
3
4
5
6
7
1.3.3 port hybrid protocol-vlan vlan
Syntax
port hybrid protocol-vlan vlan vlan-id { vlan-protocol-list | all }
undo port hybrid protocol-vlan { vlan vlan-id { vlan-protocol-list | all } | all }
View
Ethernet port view
Chapter 1 VLAN Configuration Commands
Type Value
at
ethernetii etype 0x0600
llc
snap
ipx ethernetii
ipx llc
ipx raw
ipx snap
1-9
dsap 0x01 ssap 0x02
etype 0x0700