Table of Contents
Advertisement
Flush-fit installation
Flush-fit installation is only possible in
natural stone (granite, marble), solid
wood and tiled worktops. Certain
models are suitable for building into
glass worktops - please see relevant
label on the hob. When using a work-
top made from any other material,
please check first with the worktop
manufacturer that it is suitable for in-
stalling a flush fit hob.
The internal width of the base unit un-
derneath the appliance must be at
least as wide as the inner worktop cut-
out (see "Building-in dimensions -
flush fit"), so that the hob is easily ac-
cessible from underneath after install-
ation and the bottom half of the casing
can be removed for maintenance. If
the underside of the hob is not freely
accessible after installation, any seal-
ant used to plug the gaps around the
appliance must be removed to enable
the hob to be lifted out of the cut-out
should this be necessary.
Installation notes
Natural stone worktops
The hob is set directly in the cut-out.
Solid wood worktops, tiled worktops,
glass worktops
The hob is set on a wooden frame in-
side the cut-out. The frame must be
provided on site, and is not supplied
with the appliance.
Minimum plinth height
The minimum plinth height is 100 mm.
Housing unit back panel
The extraction ducting is laid behind the
housing unit back panel. The back
panel must be removable for mainten-
ance purposes.
Drip tray
The hob must be installed such that the
drip tray is easily accessible as it needs
to be removed for cleaning.
67
Advertisement
Table of Contents
