Transmit Adjustments - Icom IC-9700 Service Manual

4-3 TRANSMIT ADJUSTMENTS

Touch [TX/ID] on the main adjustment menu screen.
ADJUSTMENT
IDLING
1
-Preparation-
2 VDL IDL Set
-Adjustment- 3 VHF ID SET
4 VHF FIDV
5 VHF DIDV
6 UHF ID SET
7 UHF FIDV
8 UHF DIDV
9 1.2G ID SET
10 1.2G FIDV
11 1.2G DIDV
VHF TX OUTPUT 1
POWER
-Preparation-
-Adjustment- 2 TX POWER VHF SET
3 TX Total VHF Gain
4 POWER VHF2 MIN
5 POWER VHF2 1%
6 POWER VHF2 10%
7 POWER VHF2 50%
8 POWER VHF2 100%
VHF TX 1 POWER VHF Balance SET • Receiving
BALANCE
2 POWER VHF1 100%
-Adjustment-
3 POWER VHF3 100%
VHF AM CARRIER
1 POWER AM Ratio VHF
POWER RATE
2
-Adjustment-
VHF ALC 1 ALC VHF
-Adjustment-
VHF DRIVE GAIN 1 DRIVE VHF
-Adjustment-
ADJUSTMENT ITEM
DISPLAY
–
–
SETTING CONDITION
–
• Receiving
• Automatically transmitted.
• Connect the RF power meter to
the [144MHz ANT] connector.
• Connect the audio generator to
[MIC] connector, and set it to:
Frequency: 1.5 kHz
Waveform: Sine wave
Level: 30 mV rms
• Receiving
• Automatically transmitted.
• Automatically transmitted.
• Receiving
• Automatically transmitted.
• Automatically transmitted.
• Automatically transmitted.
4-5 4-5
OPERATION
Touch [ID] to enter to the TX idling
current adjustment mode.
Touch [SET].
Touch [SET].
(Two beeps sound after adjustment
of each item is completed.)
Touch [VHF] to enter to the VHF
output power adjustment mode.
Touch [SET].
Set to 50 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Set to 0.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Set to 1 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Set to 10 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Set to 50 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Set to 100 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Touch [SET].
Set to 100 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of each item is completed.)
Touch [SET].
Set to 25 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
www.PH4X.com