Replacing The Vital Product Data Card - IBM 9040-MR9 Manual

Figure 6. Removing the VPD card
Replacing the vital product data card in the 9040-MR9
Follow these steps to replace the vital product data card.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the VPD card.
a) Align the VPD card in its slot on the system backplane. Refer to the following image.
b) Push the VPD card into place until it is fully seated.
Remember: If you unplugged the USB cable so that you could access the VPD card, don't forget to
reconnect it.
Vital product data card for the 9040-MR9 9