IBM 9040-MR9 Manual page 27

Figure 10. Connecting the power cords
6. When the service processor comes up to the standby state (the power-on LED on the control panel is
flashing slowly), continue to the next step.
7. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).
8. Access the ASMI.
If you are already connected to the ASMI, go to the next step.
a) For instructions, see Accessing the ASMI without an HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9hby/connect_asmi.htm).
b) Click Tasks.
c) Click Operations > Launch Advanced System Management (ASM).
9. In the ASMI navigation panel, expand Power/Restart Control > Power On/Off System. Clear Server
firmware start policy and select Standby (User-Initiated). Then, click Save settings.
10. Set the system identifiers and the activation codes for the Capacity on Demand (CoD) and
Virtualization Engine technologies (VET):
Note: To perform this operation, your authority level must be administrator or authorized service
provider.
a) In the navigation area, expand System Configuration > Program Vital Product Data.
Vital product data card for the 9040-MR9 13