IBM 9040-MR9 Manual page 20

Attention: Operating the system without the cover for more than 10 minutes might damage
the system components. For proper cooling and airflow, replace the cover before turning on
the system.
a. Push the release latches (A) in the direction shown in the following figure.
b. Slide the cover (B) off the system unit as shown in the following figure. When the front of the
service access cover has cleared the upper frame ledge, lift the cover up and off the system unit.
Figure 3. Removing the service access cover
10. To activate the identify LED for the faulty part, press and hold push-button (A) on the trusted platform
module card as shown in the following figure.
Verify that the green LED (B) is lit, which indicates that sufficient power exists for the identify LED. If
the LED (B) is not lit, use the location code to find the physical location by using the service label.
6 Power Systems: Vital product data card for the 9040-MR9