Configuring Snmp V3 - H3C MSR 900 Series Quick Start Manual

Configuring SNMP v3

Select System Management > SNMP from the navigation tree to
enter the page shown in Figure 4-8.
Figure 4-8 SNMP v3 configuration page
Select the radio button before Enable to enable SNMP.
Select the radio button before SNMPv3 to specify the SNMP
version.
Enter the information of the manufacturer in the Contact
Information field to ensure that the information is available when
needed.
Configure the system name in the Sysname field. The system
name will be displayed in the upper left of the navigation bar.
Enter the location of the device in the Device Location field so
as to facilitate location of faulty devices during troubleshooting.
4-8