H3C MSR 900 Series Quick Start Manual page 42

Figure 4-7 SNMP v1 and SNMP v2 configuration page
Select the radio button before Enable to enable SNMP.
Select the radio button before SNMPv1&v2 to specify the SNMP
version.
Configure Read Password and Read & Write Password, which
are used when the NMS performs read or read-write operations
on the device. Configure Trap Password, which is used for
authenticating the trap messages sent from the device to the
NMS.
You can specify the IP address of the NMS trusted by the agent
in the Trusted Host field as needed. Thus only the specified
NMS can access the device. Any NMS can access the device if
this field is not specified.
Specify the IP address of the host to which the SNMP trap
messages are sent in the Trap Target Host field.
Click Apply to finish the configuration.
4-7