Table of Contents
Advertisement
D. Manually Resetting the Security Code to Enter Programming
Note: This procedure will not erase a username and password used to access the 40TB-IP program mode. Only the security code is set to default.
Step 1.
Power down the 40TB-IP speaker by disconnecting the LAN Cable (RJ45 plug).
Step 2.
Press and hold the Reset button, then reconnect the LAN Cable (RJ45 plug).
Continue to hold the Reset button until you hear a single beep, silence and then 2 beeps (approximately 11 seconds). Then release
Step 3.
the button. The LED will remain off for 5 seconds, light steady for 3 seconds, flash slowly for 3 seconds then fast flash (after the 2
beeps), indicating when to release the button.
Step 4.
The security code is now reset to 845464 (factory default).
Step 5.
You can now enter programming by following the steps in section A.
E. Manually Resetting All Network Parameters to Factory Default
Note: This procedure will erase a username and password that are used to access the 40TB-IP program mode.
Step 1. Power down the 40TB-IP speaker by disconnecting the LAN Cable (RJ45 plug).
Step 2. Press and hold the Reset button, then reconnect the LAN Cable (RJ45 plug).
Continue to hold the Reset button until you hear a single beep, silence and then 2 beeps (approximately 11 seconds). Continue to
hold reset button until you hear 4 more beeps (approximately 6 seconds later), then release the button. The LED will remain off for 5
Step 3.
seconds, light steady for 3 seconds, flash slowly for 3 seconds (two beeps), fast flash for 6 seconds (4 beeps), then light steady
indicating when to release the button.
Step 4. You can now enter programming by following the steps in section A.
DESCRIPTION
Connect / Disconnect
VLAN Settings
Unit Name
SIP Server
Peer to Peer Settings
Outbound Proxy
Authentication ID
Register Fails (Re-Resolve or Alternate Server)
Line Out Control
DTMF Regeneration
Pre Page Alert Tone
SIP Page / Call Priority VS Multicast
Multicast Paging
Multicast Paging Volume (0 - 1 9, factory set to 1)
Non-Emergency Phone Numbers and Emergency Phone Numbers
Security code (factory set to 845464)
ID Number
Access Code (1 - 6 digits, blank = Disabled, factory set to 123456)
Audio File
Recording Emergency Announcement from a phone
Internal / External Relay (factory set to Internal)
Relay Mode
(Door Strike, Outbound Call, Phone or Paging, Doorbell, Alarm Mode, Ring, Ring Flash, factory set to Door Strike)
NOTE: Normally closed modes can also be programmable.
Relay Activation Command (1 or 2 digits, factory set to ,,) NOTE: Relay Mode must be set to Door Strike.
Relay Activation Time (0.5 - 99 seconds, factory set to 5 seconds)
Relay Buzz Volume (1 - 3 or Disabled, factory set to 3)
Relay Latch Commands
(Enabled or Disabled, factory set to Enabled) NOTE: Relay Mode must be set to Door Strike
Panic Button mode (Enabled or Disabled, factory set to Disabled)
Programming Features Index
9
Section
Page
A
7
C
8
1
10
2
10
3
10
4
11
5
11
6
11
7
11
8
11
9
11
10
12
11
12
12
12
13
13
14
13
15
13
16
13
17
13
18
14
19
14
20
14
21
15
22
15
23
15
24
15
25
15
Advertisement
Table of Contents
