Table of Contents
Advertisement
27. SIP Page / Phone Volume
The SIP Page / Phone volume can be set from 0 - 19. 0 = lowest volume setting, 19= highest volume setting. Adjusting
this will set the Speaker and Line Out volume level for SIP Paging and incoming/outgoing phone calls. This setting
does not affect multicast volume settings. Factory Setting: 1
The SIP Page / Phone volume can alternatively be set to Auto 0 – 10, 15 or 19. 0 = the lowest automatic volume setting
and 10, 15 or 19 = the highest automatic volume setting. With volume set to auto the 40TB-IP will use its built-in
microphone to monitor background room noise and automatically increase or decrease the Speaker and Line Out
volume for SIP paging, incoming/outgoing phone calls and Multicast paging. Note: The minimum volume setting for
multicast paging is set separately per multicast IP address and port. See "Paging" menu in Viking IP Programming.
28. Ring Volume
When set to Ring or Ring with AGC, The 40TB-IP will output a loud ring when it is called. The level can be adjusted
from 0 - 19. Factory Setting: 5
29. Microphone Volume / Automatic Noise Cancelling Mode
The microphone volume can be set from 1 - 9, 1 = lowest volume setting, 9 = the highest volume setting. Alternatively
the microphone can be placed in the "Auto" Automatic Noise Cancelling mode. With the mic in the Auto mode, when
background noise increases, the mic gain will automatically decrease. When background noise decreases the mic gain
will automatically increase. The Auto mode is useful in applications where the background noise level can change
drastically. Factory Setting: 5
30. Talk / Listen Delay (VOX)
This feature selects switching time between talk and listen modes (VOX switching time). The Talk / Listen Delay can
be programmed from 0.1 - 0.9 seconds. Factory Setting: 0.5 seconds
31. In-Band Audio Call Progress
The In-Band Audio Call Progress Detection can be set to enabled or disabled. In-Band Audio Call Progress detection
should be enabled in applications where you are making an outbound call through your VoIP phone system and are
relying on In-Band analog audio for ringback or busy detection. Factory Setting: Enabled
32. In-Band Audio Detect Sensitivity
The In-Band Audio Detection level (Sensitivity) can be set from 1 to 9,1 = minimum setting, 9 = highest setting.
Increasing or decreasing the sensitivity may be required in applications where you are making an outbound call through
your VoIP phone system and are relying on In-Band analog audio detection. Factory Setting: 5
33. Repeat Announcement Option
The 40TB-IP speaker phone can be programmed to play the announcement 1 - 9 times, or to continuously repeat the
announcement every 6 seconds until a touch tone
on automatically after the announcement has stopped repeating. Factory Setting: 1 (play the announcement 1 time)
34. Lap Counter
With the lap counter disabled, if the 40TB-IP speaker phone is programmed to dial the next number on ring-no-answer
and/or busy signal, the 40TB-IP speaker phone will continuously call its programmed phone numbers forever until the
call is answered.
The lap counter is a programmable counter that determines how many times the 40TB-IP speaker phone will cycle
through its list of up to 5 non-emergency phone numbers (or up to 5 "Emergency" phone numbers), before it stops the
dialing process and hangs up. When all of the programmed phone numbers have been dialed, the lap counter is
incremented and the dialing process repeats. When the lap counter has been met, the dialing process stops and the
40TB-IP speaker phone hangs up.
Factory Setting: Disabled
is detected from the distant party. The call / status LED will turn
,
16
Advertisement
Table of Contents
