Table of Contents
Advertisement
44. Permanent Alarm Mute
Alarm Tones are disabled by default. To enable alarm tones select "Alarm Tones Enabled".
45. Programming Username and Password to Restrict Access to Programming
To increase security, a username and password can be programmed to limit access to the 40TB-IP using Viking IP
Programming software. When no username and password are programmed and the security code is still set to default
(845464), the PC software will not require a username, password or security code when connecting to the 40TB-IP. If
the 40TB-IP has been programmed with a username and password, a pop up window will ask for the username followed
by the password. If the unit's security code has been changed from default (845464), it will then prompt for the correct
security code.
If the username and password are unknown, they can only be erased by resetting all network parameters to default
with the reset button (see section E on page 9). If the username and password are known but you wish to erase them,
that can be accomplished by exporting the data from the 40TB-IP ("Alarm / Firmware" tab of Viking IP Programming),
resetting all network parameters to default with the reset button (see section E on page 9) and then importing the data
back into the speaker.
46. IP Firmware
Update IP is currently not available. The ability to update IP firmware will be made available in a later release of Viking
IP Programming software. If an IP firmware update is needed, Viking Technical Support will assist in updating the IP
firmware.
47. Unit Firmware
If new 40TB-IP firmware is available, after opening the programming software a pop up window will ask if you would
like to update firmware. Another way to update is accomplished by clicking the speaker firmware "Update Unit" button.
You can then browse to the folder that contains the HEX file for updating the unit's firmware. This method is typically
only used when Viking Technical Support has sent you updated firmware.
48. Import / Export
The Import / Export feature is useful for backing up all the 40TB-IP's programming or for importing programming when
installing multiple units with a majority of the same programming.
49. Clear Speaker Settings
Clicking on the "Clear Speaker Settings" button in programming will reset all of the Programming Features back to
their factory default settings. NOTE: This command will not change or reset your IP settings.
50. Clear IP Settings
Clicking on the "Clear IP Settings" will reset all of the IP settings back to their factory default settings. This also clears
paging Group settings and Addresses. NOTE: This will not affect any speaker or paging settings.
19
Advertisement
Table of Contents
