Table of Contents
Advertisement
4. Outbound Proxy
If your SIP provider requires an outbound proxy IP address enter it in the "Outbnd Proxy" field. If outbound proxy is not
required enter the SIP sever IP address into the "Outbnd Proxy" field. NOTE: If not required, this field must match your
SIP server IP address.
5. Authentication ID
If your SIP provider requires Authentication ID, enter it in the "Authentic. ID" field. If Authentication ID is not required,
leave this field blank.
6. Register Fails (Re-Resolve or Alternate Server)
When registered to a SIP server in the event that registration is lost you can program the unit to re-resolve using the
current SIP server IP address or route pages through an alternate SIP server. With Alternate Server selected enter the
IP address of the alternate SIP server in the field next to the Register Fails drop down box. Note: With an alternate
SIP server IP address programmed, the IP address for the SIP server and alternate SIP server will be limited to 31
characters.
7. Line Out Control
When "Line Out Control" is set to Enabled SIP call audio will be heard from the Line Level Output. When this feature is
Disabled, the Line Level Output is muted during SIP calls to allow for a private conversation. Multicast paging will still
be heard from the Line Level Output. Factory Setting: Enabled
8. DTMF Regeneration
When "DTMF Regeneration" is Enabled, any touch tones entered by the caller (in band or out of band) will be passed
along to the line out and speaker out. These tones are used by an external amplifier for choosing which zone to send
the page audio to. Factory Setting: Disabled
9. Pre Page Tone
When enabled, a short beep will be heard prior to SIP or Multicast paging audio. The volume of the Pre Page Alert Tone
will match the volume setting of the SIP or Multicast page. Factory Setting: Enabled
11
Advertisement
Table of Contents
