Table of Contents
Advertisement
35. SIP Page / Call Length Timeout
This feature selects the maximum length of time that calls can be connected. Programmable in increments of 1 minute
up to a maximum of 9 minutes or disabled. With the call length disabled, the 40TB-IP speaker must rely on a call ended
signal, busy signal, Ring No Answer limit, or touch tone # to hang-up. Factory Setting: 3 minutes
36. Multicast Page Length Timeout
The Multicast Page Length Timeout can be programmed from 1 - 255 seconds in one second increments. The Time
Out can be disabled, allowing any length of page or continuous background music. A timeout check box can be selected
for each paging group. Only one timeout time can be programmed for all multicast paging groups.
Factory Setting: 180 seconds
The Inbound Call Mode determines how the 40TB-IP handles incoming SIP calls. One option is to generate a loud
ring sound through the speaker. The 40TB-IP can also auto answer a SIP call to transmit a page, control the relay or
listen to transmit audio from the microphone. The last option is the silent monitor mode, which allows callers to listen
to the transmit audio from the microphone. The "secure" options for auto answer require the callers to dial the access
code in order to transmit a page, activate the relay or activate the optional RC-4A relays. Factory Setting: Auto Answer
Disabled: Inbound SIP calls are not allowed.
Auto Answer: Inbound SIP calls are auto answered on the first ring. This can also be used for Silent Monitoring by
changing the speaker mode to "OFF / Silent Monitor", see page 15. For more security use the Auto Answer Secure
Mode.
Auto Answer Secure: Inbound SIP calls are auto answered and the caller must dial the access code in order to listen
or talk on the unit.
Ring: In the "Ring" mode the speaker phone will not automatically answer an incoming call but will output a loud ring
signal out of the speaker in a factory programmed 2 seconds ON, 4 seconds OFF ring pattern. There are four available
ring cadences.
Ring with AGC: In the "Ring with AGC" mode the speaker phone will not automatically answer an incoming call but
will output a loud ring signal out of the speaker in a 2 seconds ON, 4 seconds OFF ring pattern. The speaker will
automatically increase or decrease the ring volume based on background ambient noise. The call can then be answered
by momentarily pressing the "reset" button or the center button on the optional BTR-3 Remote.
38. Ring Cadence
39. Dial Next Number on Ring No Answer
If enabled and a ring-no-answer is detected, the speaker phone will dial the next programmed phone number or
emergency phone number. A momentary press of the "reset" button will dial the first programmed phone number.
Pressing and holding the "reset" button for 3 or more seconds will dial the first Emergency Phone number.
Factory Setting: 7 (will redial after 7 rings)
40. Dial Next Number on Busy
If enabled and a busy is detected, the speaker phone will dial the next programmed phone number. A momentary press
of the "reset" button will dial the first programmed phone number. Pressing and holding the "reset" button for 3 or more
seconds will dial the first Emergency Phone number. Factory Setting: Enabled
17
Advertisement
Table of Contents
