Table of Contents
Advertisement
Typical Installation on SIP Based VoIP Phone System
Viking
40TB-IP
Viking
Customer's
supplies
Responsibility
* Note: A PoE extender can be used for an additional 100 meters per extender. For longer
runs (up to 2 km / 1.2 miles) a ethernet to fiber media converter can be used.
• IBM compatible personal computer with:
Windows 7, 8 or 10
• Adobe Acrobat Reader 8 or higher
• 40TB-IP hardware
Download and install the programming software
1. Go to www.vikingelectronics.com and enter 40TB-IP in the search box
2. Click 40TB-IP in the search results
3. Scroll down the page to Downloads, click IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on setup Viking IP
Programming.exe
5. Follow the prompts on your screen to complete software installation
6. To start the Viking IP Programming application, click on the Viking IP Programming icon on your desk top.
The main screen will appear, allowing the user to program any 40TB-IP connected to that LAN.
Note: PC must be connected to the same LAN as the 40TB-IP.
100m (328 ft) maximum*
10/100 Mbps
Maximum
Optional
PoE Injector
(If VoIP PBX does
not have PoE)
PC Requirements
PC Programming
SIP VoIP PBX
or
PC with
SIP Server
Software
Optional
Switch / Hub
(Extends range of cable, keeps
1 Gbps network speed for other
equipment on network)
• Available LAN with PoE (class 3, <13 Watts)
• Ethernet cable (CAT5 minimum)
• 1 MB minimum free hard drive space for installation
• 16MB of free physical RAM
6
Internet
Optional Viking model
RC-4A Secure Remote
Relay Controller, see
page 22 (DOD 582)
Advertisement
Table of Contents
