Chamberlain EL Series Programming Manual page 65

Direct Commands from Your Phone:
Direct command allows you to control the unit from the residence phone.
Speaking Through the Unit (Intercom Mode):
Press
1
The unit is now prepared to accept a direct command.
2 Enter the Unit ID code (if applicable).
ABC
Press
3
Open & Close Door:
Press
1
The unit is now prepared to accept a direct command.
Enter the Unit ID code (if applicable).
2
ABC
Press
3
4 Select the Door (1-4) that you want to control. Press
NOTE: If no door is selected then Door 1 is used.
Toggle Door Open/Close Until:
Press
1
The unit is now prepared to accept a direct command.
2 Enter the Unit ID code (if applicable).
ABC
Press
3
Select the Door (1-4) that you want to control. Press
4
NOTE: If no door is selected then Door 1 is used.
5 ONLY for step #2 sections Toggle Door Open/Close Until and Get Door Status
Enter the Latch Time (hhmm=Hour and Minute). Then
120 121 122
from the residence phone.
Then
from the residence phone.
Then
from the residence phone.
ABC
Then
64
Used to initiate communications from the
resident phone through the unit at any time.
Cycles relay. Typically used to momentarily
open a door/gate for a visitor without having
the visitor initiate a call.
Activate or deactivate the door's relay group
until a specified time of day. If the door is
currently latched open or in the unlock
position of an automatic time zone then step
122
will latch the door closed and vice versa.