Chamberlain EL Series Programming Manual page 31

Add or Edit Full Function Directory Code:
When adding a full function Directory Code, it will default as "active". To deactivate a code, or deactivate on a
specific time and date, see Activate or Deactivate a Directory Code on page 32.
Press
1
Enter Directory Code (up to 2 digits). Then (#)
2
3 Enter Phone Number (up to 20 digits). Then (#)
Enter Phone Extension (up to 5 digits). Then (#)
4
Enter Do Not Disturb Schedule (0-63). Then (#)
5
0=May always be disturbed
1=Never disturb
Enable (1) or Disable (0) Call Forwarding. Then (#)
6
Do Not Disturb Schedule = 0
Factory
Call Forwarding Enable or Disable = 0
Settings
Call Forwarding Schedule = 0
EXAMPLE
:
1
Adds Directory Code "45" with phone number "555-2134", phone extension "432", uses Do Not
Disturb schedule 2 and disables call forwarding.
Change a Directory Code ONLY:
Allows you to change ONLY the Directory Code without affecting the other data associated with the record (e.g.,
phone number, do not disturb schedule, etc.).
1 Press
The New Directory Code Number (Up to 4 digits). Then (#)
2
The Current Directory Code number (Up to 4 digits). Then (#)
3
EXAMPLE:
Delete a Directory Code:
1 Press
2 Enter the Directory Code number to be deleted (Up to 4 digits). Then (#)
EXAMPLE:
Then
2 3
44
Then
1
Changes Directory Code from "14" to "23".
48
Then
1
Deletes Directory Code "23".
41
Enter Call Forward Schedule (0-63). Then (#)
7
0=Never Use Call Forward Number.
1=Use Call Forward Number.
Only Enter New Call Forward Phone Number (up to 20
8
digits). Then (#)
(Skip this step to keep existing Call Forward Phone
Number.)
Enter Call Forward Phone Extension
8A
(up to 5 digits). Then (#)
(If using an extension the unit MUST have a
phone number.)
4 5
2 3
2
30
6 7 8 8A