Chamberlain EL Series Programming Manual page 54

Number of Rings Before Unit Answers:
When someone remotely calls the unit for programming, the unit answers the call after a configurable number
of rings. Factory Setting: 5 Rings
Press Then
1
Enter Number of Rings (0 to 15). Then (#)
2
"0" disables the unit and no incoming calls will
be answered. It will NOT be ableto be remotely
programmed.
NOTE: If you have an answering machine (or answering service) attached to the same phone line as the unit, set
the unit count for two (2) or more rings higher than the answering machine/service count. See also Override
Telephone Company Answering Service (See Below).
Override Telephone Company Answering Service:
You can override an answering service by dialing the line attached to your unit, letting the phone ring only once or
twice, then hang up. After a few seconds, dial the same number again. The unit will immediately answer the
second call. If you do not call back within 60 seconds, this feature will reset and you must start over.
Factory Setting: Disabled
Press
1
2
Enable (1) or Disable (0). Then (#)
Enable or Disable Telco Mode:
Telco mode is using the main telephone line for the unit's communications to a house or complex.
Enable the Telco mode if the unit will use a regular telephone line.
Disable the Telco mode if the unit will not have a regular telephone line connected to it. If the Telco mode is
disabled and the unit is connected to a regular telephone line, it will ignore all Telco features (call forwarding, call
waiting, etc.). Factory Setting: Enabled
1 Press Then
Enable (1) or Disable (0). Then (#)
2
Dial "0-9" First to Get an Outside Line Using an Automated
113
Phone System:
When the unit is connected to a PBX telephone system (Automated), it can be programmed to dial a specific
PBX number (0-9) then pause briefly, allowing the PBX system to give the unit an outside line.
Factory Setting: Disabled
1 Press
2 Enable (1) or Disable (0). Then (#)
EXAMPLE:
Enables Unit to dial "9 and Pause" to connect to an outside line.
Then
EXAMPLE:
Override is enabled. The EL25 will answer the second call after a
configured number of rings, hangup and callback is preformed.
20
3 Enter Specific PBX Digit (0-9). Then (#)
Then
1
53
16
EXAMPLE:
1
Unit will Answer a Remote Call after 7 Rings
109
1
EXAMPLE:
1
Telco mode is disabled.
2 3
2
2
2