Table of Contents
Advertisement
OPERATING AND COMMISSIONING INSTRUCTIONS
V.5.a. Menu configuration en accès service
Configuration
1.
Regulation type choice (see chapter V.5.b.1)
2.
Parameters modification Night Cooling (see chapter V.5.b.2)
3.
CO2 set point modification (only in DIVA and QUATTRO) (see chapter V.5.b.3)
V.6. Modification of the services parameters (password 2222)
V.6.a. Regulation mode of the unit
[(1) chapter V.5.a]
Access : Configuration / Regulation function.
Regulation type is set by default in the CORRIGO controller in outside compensation exhaust. You can also select return
control mode.
(ATTENTION, if you want to regulate following a room temperature, select the regulation mode« Ctrl extract » Any
other mode will lead to the failure of the unit)
V.6.b. Overventilation parameters
[(2) chapter V.5.a]
Access : Configuration / Night cooling
Night cooling speed is set in standard in 85%. You can modify it. You can also change the temperature of Night Cooling
activation (outside temperature day...) and deactivate it.
V.6.c. CO2 setpoint for DIVA / QUATTRO option
[(3) Chapter V.5.a]
Access: Configuration / Ctrl CO2/COV
CO2 setpoint is set in standard: LS = 800ppm HS = 1000ppm. Unit will increase its speed proportionally to reach its maximum
speed when CO2 will be at 1000ppm.
MS-CDF-010
Regulation Function
Night Cooling
Ctrl CO2/VO
Ind F
Maj. 18/05/2017
® -
FREETIME
HEXAMOTION
High Efficiency Recovery Unit
Regulation Function
Mode:
Supply t+comp ext (1)
Night cooling activated : YES (2)
Outdoor temp activation : 22°C (2)
Outdoor T° night
High 18°C (2)
Low 10°C (2)
Room mini Temp: 18°C (2)
Speed : 85%
Ctl CO2/COV activated :
If timer ON
Type : Fans
Speed 1/2 : 800 ppm (3)
Speed 1/1 : 1000 ppm (3)
Diff : 160ppm
Créé par : JC
®
Validé par : AR
Page 35/57
Advertisement
Table of Contents
