Table of Contents
Advertisement
Beyond Initial Setup
HP StorageWorks NAS Software Updates
Once cluster installation is complete, it is necessary to upgrade Services for Unix
and NAS DataCopy (if installed) to make them cluster aware. Select the link at the
bottom of the Cluster Setup Guide located under the HP Utilities tab in the WEB
User Interface to perform the software updates. If DataCopy is installed after the
cluster is installed, DataCopy will automatically become cluster aware.
Note:
Configuring Physical Disk Resources after the Cluster Install is Complete
Once the cluster installation is complete it may be necessary to add additional
physical disk resources into the cluster. The procedure outlines the steps to
complete this process. This can be accomplished at the server console, or remotely
through terminal services or the iLO port.
66
Complete this procedure on both cluster nodes.
Present the LUN(s) to Node A, do not present the LUN(s) to Node B at
this time.
On Node A, open Disk Manager and write the disk signatures and create
the partitions. Remember that disks can only be basic in a cluster.
— To open Disk Manager select Start-Run-diskmgmt.msc.
— A volume label must be assigned when the partition is formatted.
On Node A, open Cluster Administrator and create the Physical Disk
Resources.
— Select Start-Run-Cluadmin . to open Cluster Administrator.
— To create a physical disk resource in Cluster Administrator select
File-New-Resource.
— If the new disks do not appear in the disk selection list, Node A must
be rebooted.
After all new LUN(s) have been added to the cluster, present the LUN(s)
to Node B.
On Node B, open Device Manager and scan for new devices.
Move the new Physical Disk Resources to Node B.
— To move the Physical Disk Resource, right click on the cluster group
the disk resides in and select Move Group.
NAS e7000 v2 Quick Start Guide
Advertisement
Table of Contents
