Clustered Nas E7000 V2 - HP StorageWorks NAS e7000 V2 Quick Start Manual

6. Place the NAS device into an active directory or Windows NT 4.0 domain for
7. While the system is online, assign the LUNs to the NAS device one at a time
8. Using Logical Disk Manager, write signatures to the disks, mark them as
9. Create shares and assign share permissions.
10. This is an optional step. Enable protocols such as NCP and/or AppleTalk as
11. This is a recommended step. Create shares corresponding to the protocols
12. This is a recommended step. Activate the iLO License Key. The iLO
13. This is an optional step. Install NAS Data Copy for replication services
14. Read the remaining sections of the administration guide which detail the steps

Clustered NAS e7000 v2

The following describes how to configure the NAS e7000 v2 as a clustered pair.
1. Request storage from the SAN administrator referencing the suggestions
2. Set up each NAS device in the cluster using either Chapter 2 or 3 from this
3. Identify the firmware, storage network topology (hub vs. switch), and storage
NAS e7000 v2 Quick Start Guide
ease of manageability. This is not required for stand-alone systems, but it is
recommended.
so that they can be identified easily in Device Manager. See the procedure in
the storage management section of the administration guide.
basic or dynamic, create corresponding partitions, extended partitions or
volumes, assign drive letters, and format the drives. See the LDM online help
for full details on this procedure.
desired. See the administration guide for this procedure in detail.
mentioned in the previous steps. Grant access rights to the shares.
License Key is included in the country kit.
among NAS or server products. A thirty day trial license is included with
NAS operating system.
and processes for utilizing the NAS device.
made in this guide and the storage management section of the administration
guide. The LUNs will need to exist on the SAN prior to completing setup. A
mirrored quorum disk and at least two additional logical unit numbers (LUNs)
will be required to allow each node of the cluster to manage file system
resources.
guide.
controller features in use on the SAN. Prior to connecting any fiber cables,
utilize the SAN Connection tool included in the HP Utilities Tab of the
Product Overview
23