Configuring The Second Node; Verifying Installation - HP StorageWorks NAS e7000 V2 Quick Start Manual

Beyond Initial Setup

Configuring the Second Node

Note:
Installing Cluster service on the second node requires less time than on the first
node. Setup configures the Cluster service network settings on the second node
based on the configuration of the first node.
Installation of Cluster service on the second node begins exactly as for the first
node. During installation of the second node, the first node must be running.
Follow the same procedures used for installing Cluster service on the first node,
with the following differences:
1. In the Create or Join a Cluster dialog box, select The second or next node
2. Enter the cluster name that was previously created (in this example,
3. Leave Connect to cluster as unchecked. The Cluster Service Configuration
4. Enter the password for the account (if there is one) and click Next.
5. At the next dialog box, click Finish to complete configuration.
6. The Cluster service will start. Click OK.
7. Close Add/Remove Programs.

Verifying Installation

There are several ways to verify a successful installation of Cluster service. Here
is a simple one:
1. Click Start>Programs>Administrative Tools and click Cluster
64
For this section, leave the first node on and power up the second node.
in the cluster, and click Next.
MyCluster), and click Next.
Wizard will automatically supply the name of the user account selected during
the installation of the first node. Always use the same account used when
setting up the first cluster node.
Administrator.
NAS e7000 v2 Quick Start Guide