Table of Contents
Advertisement
Configuration Setup
Note:
5. Using the information from
6. Click the Finish icon to complete Rapid Startup. If a reboot is required, Rapid
7. The browser will refresh to the status page of the NAS device. The refresh
8. For cluster deployments only, repeat steps 3 - 7 with the second node. After
44
The NAS device will respond when the NAS operating system has started.
your information is correct when the configuration review screen is displayed,
as shown in
Figure
10. Online help is available for all pages by clicking the
"?" in the right side of the Web UI.
Startup will present a message that a reboot is occuring.
may take several minutes if the device was restarted. Click on the HP utilities
tab and select the SAN Connection Tool. Do not connect storage until
instructed to do so by the tool.
the second node is configured, follow the online Cluster Install Guide found in
the Cluster tab of the Web UI. Additional information can also be found in
Chapter 4 of this document as well as the cluster section of the administration
guide.
Table
3, fill in the screens that follow. Verify that
NAS e7000 v2 Quick Start Guide
Advertisement
Table of Contents
