Advertisement
Transmitter
LED 1 pulse
Button
Default setting
Gasoline engine.
The glow plug
wire (diesel wait
E1
light) not use.
Cranking time
0.8 s
E2
detects engine
running by
increasing low
E3
level of power
voltage
Each time remote
engine running
5 minutes
E4
FEATURE "F" PROGRAMMING
- turn off ignition
- press override button 3 times
- turn on ignition
- parking lights flash and siren chirps 3 times
- push the Valet Switch 11 times.
- one long chirp with 11 short chirps is heard.
You are now in the start feature "F" programming mode.
- press and release the transmitter button corresponding
to the feature you want to program.
Exit feature programming: After 20 sec or turning off ignition system will get out the feature
programming setting procedure, parking lights flash 4 times.
Press
one chip
Transmitter
LED 1 pulse
LED 2 pulse
LED 3 pulse
Diesel engine.
Diesel engine.
10 seconds
The glow plug
warm-up timer
wire must
The glow plug
connect positive
wire not use.
diesel wait light.
(max 120 sec.)
Cranking time
Cranking time
3.6 s
1.8 s
detects engine
detects engine
running by
running by RPM
increasing hi level
type
of power voltage
Each time remote
Each time remote
engine running
engine running
10 minutes
15 minutes
two chip
three chip
LED 2 pulse
LED 3 pulse
17
LED 4 pulse
Diesel engine.
The glow plug
wire must
connect negative
diesel wait light.
(max 120 sec.)
Push button start
detects engine
running by
GENERATOR
Each time remote
engine running
20 minutes
four chip
LED 4 pulse
Advertisement
