Advertisement
If function on:
- pull up hand brake while engine is running
- turn ignition key off and take out the key (engine is still running)
- engine will run for the programmed duration
To stopping engine press button
31. Mid-gear procedure (for manual gear only)
If you are going to leave the vehicle the following procedure must be performed (It is
need for safety engine auto start):
- ignition key is on, engine running
- pull up hand brake
- press and hold 2 sec. button
- turn ignition key off and take out the key (engine is still running)
- get out the vehicle and close the door
- after close the door, system shut down engine.
- system shut down engine 1 minute later button
arming (and door locking) by remote.
This procedure must be performed each time before getting out the vehicle. Open door
will cancel the setting.
32. Learn tachometer (RPM)
turn off ignition
- press override button 7 times
- turn on ignition
- parking lights flash and siren chirps 7 times
- press override button 6 times
- siren chirps 2 times
Start the vehicle with the key. while the engine is running, the parking will flash. if don't,
please check tachometer wire connection.
Press
on transmitter to record the RPM. Chirp once to confirm.
Press
on transmitter to exit the RPM learn mode. chirp 4 times and flash 4 times
33. Remote engine start
Press and hold 2 sec. button
If engine isn't started up from first, the system will automatically total start the engine 4 times.
Cranking time (program feature E-2) of each next attempt will be increased by 0.2 sec.
once. Parking flash once for confirm.
, parking lights flash once
to remote engine start, parking light flash twice to confirm.
10
pressing or immediately after
Advertisement
