Inserting A Scene From A Vcr – Insert Editing - Sony DCR- Operating Instructions Manual

Inserting a scene from a VCR – Insert Editing
(1) Set the POWER switch to VCR on your camcorder.
(2) On the connected VCR, locate just before the insert start point [a], then press X
(3) On your camcorder, locate the insert end point [c] by pressing m or M.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
(5) On your camcorder, locate the insert start point [b] by pressing m. Press
(6) First press X on the VCR, and after a few seconds press X on your camcorder
4
ZERO SET
MEMORY
To change the insert end point
Press ZERO SET MEMORY again after step (5) to make the ZERO SET MEMORY
indicator disappear and begin from step (3).
124
to set the VCR to the playback pause mode.
Then press X to set your camcorder to the playback pause mode.
MEMORY indicator flashes and the end point of the insert is stored in
memory. The tape counter shows "0:00:00."
z REC and the button on its right simultaneously, then immediately press X
to set your camcorder to the recording pause mode.
to start inserting the new scene.
Inserting automatically stops near the zero point on the counter. Your
camcorder automatically stops. The end point [c] of the insert stored in
memory is canceled.
ZERO SET
5
0:00:00
MEMORY
PAUSE
REC