Sony DCR- Operating Instructions Manual page 99

Dubbing a tape easily – Easy Dubbing
Step 2: Setting the VCR to operate with your camcorder
Signals to control the VCR are sent from your camcorder's infrared rays emitter to the
VCR's remote sensor.
When you connect using the A/V connecting cable, follow the procedure below, steps
(1) to (4), to send the control signal correctly.
(1) Setting the modes to cancel recording pause on the VCR
1 Set the POWER switch to PLAYER on your camcorder.
2 Turn the power of the connected VCR on, then set the input selector to LINE.
When you connect a video camera recorder, set its power switch to VTR/
VCR.
3 Press EASY DUB to display the menu.
4 Turn the SEL/PUSH EXEC dial to select SETUP, then press the dial.
5 Turn the SEL/PUSH EXEC dial to select PAUSE MODE, then press the
dial.
6 Turn the SEL/PUSH EXEC dial to select the mode to cancel recording
pause on the VCR, then press the dial.
1
3
EASY DUB
CCD-TRV418
E A S Y D U B B I N G
0 0 : 0 0 : 0
S T A R T
T I T L E S E L
M O D E S E L
S E T U P
NORMAL
[ E A S Y D U B ] : E ND
4
E A S Y D U B B I N G
5
E A S Y D U B B I N G
0 0 : 0 0 : 0
S E T U P
I R SETUP 3
PAUSE MODE
I R TEST
R E T U R N
NORMAL
[ E A S Y ] : E ND
D U B
0 0 : 0 0 : 0
S E T U P
I R SETUP
P A U S E
PAUSE MODE
I R TEST R E C
R E T U R N P B
NORMAL
[ E A S Y ] : E ND
D U B
99