Step 2 Setting The Date And Time - Sony DCR- Operating Instructions Manual

Step 2 Setting the date and time

Set the date and time when you use your camcorder for the first time.
"CLOCK SET" will be displayed each time when you set the POWER switch to
CAMERA or MEMORY unless you set the date and time settings.*
If you do not use your camcorder for about three months, the date and time settings
may be cleared from memory (bars may appear) because the built-in rechargeable
battery will have been discharged (p. 249).
Set the date and time after charging the built-in battery fully.
Set the year, then the month, the day, the hour and then the minute.
(1) Set the POWER switch to CAMERA or MEMORY, and then press MENU to
(2) Turn the SEL/PUSH EXEC dial to select CLOCK SET in
(3) Turn the SEL/PUSH EXEC dial to select the desired year, then press the dial.
(4) Set the month, day and hour by turning the SEL/PUSH EXEC dial and
(5) Set the minute by turning the SEL/PUSH EXEC dial and pressing the dial by
(6) Press MENU to make the menu settings disappear.
* Modes on the POWER switch vary depending on models (p. 16).
26
display the menu settings.*
dial.
pressing the dial.
the time signal. The clock starts.
1,6
MENU
2
SETUP MENU
– – : – – : – –
CLOCK SET
USB STREAM
LTR SIZE
LANGUAGE
DEMO MODE
RETURN
[ MENU ] : END
3
2003 JAN 1
12 00 AM
5
SETUP MENU
CLOCK SET
USB STREAM
LTR SIZE 2003 JUL
LANGUAGE
DEMO MODE
RETURN
5 30 PM
[ MENU ] : END
, then press the
SETUP MENU
CLOCK SET
USB STREAM
LTR SIZE 2003 JAN
LANGUAGE
DEMO MODE
RETURN
12 00 AM
[ MENU ] : END
2003 JAN 1
12 00 AM
SETUP MENU
CLOCK SET JUL 4 2003
5 : 30 : 00 PM
USB STREAM
4 LTR SIZE
LANGUAGE
DEMO MODE
RETURN
[ MENU ] : END
1