Chip Length Adjustment - Farmi Forest Corporation CH380HF Operation, Maintenance And Spare Parts Manual

CHIP LENGTH ADJUSTMENT

Chip length is determined by the distance
between the knives and the disc. Chip length is
adjusted by moving the knife holders. The chip
length can range between 10-30 mm.
Chip length adjustment
10-30 mm
Chip length adjustment
Knife holder adjustment direction
1. Firstly, follow the "Opening and removal of
the upper chamber" instructions.
2. To extend the chip length, first remove the
anvil fastening bolts M16 (A)
3. Move the anvils further from the disc.
CH380HF
4. Remove the knife holder fastening nuts,
M24. Set both ends of the knives to the same
distance from the disc. Use the adjustment
screws for this purpose.
Removing the knife holder nuts
Knife holder adjustment screw
5. Tighten one of the knife holder nuts and
re-check the distance measurement at the
other end.
Adjust the remaining knives as follows:
1. Take the guide measurement from both ends
of the knife you have just positioned. The
guide measurement is the distance between
the knife edge and the chamber.
31