Mounting; Lifting; Power Take-Off Shaft - Farmi Forest Corporation CH380HF Operation, Maintenance And Spare Parts Manual

MOUNTING

LIFTING

The lifting points are marked
on each machine with hook
!
symbols
CAUTION!
Only use appropriate lifting equipment of
sufficient lifting capacity to lift the equipment.
Lifting belts, cables and chains used for lifting
must be checked regularly.
The weight of the load to be lifted must be
known. Never exceed the lifting capacity limit
specified by the lifting device manufacturer.
Avoid lifting equipment over areas where people
may be present.
MOUNTING
o Attach the chipper to the tractor's 3-point
hitch.
o When handling the chipper, ensure that it is
coupled to the 3-point hitch.
o Check that the power take-off (PTO)
drive shaft is the correct length. For details
on shortening the PTO shaft see the
Power Take-Off Shaft" section.
o Check that the PTO shaft shields are in
place and the shield rotation prevention
chain is attached.
CH380HF

POWER TAKE-OFF SHAFT

CAUTION!
PTO shaft recommendations:
o Bondioli & Pavesi 10 (106 kW / 540 rpm)
with overrunning clutch
o Walterscheid W2600 + F3 with overrunning
clutch
If the tractor is equipped with a power-take-off
break, use the overrunning clutch.
CAUTION!
17
Tractor's PTO drive shaft
dimensions should be
!
1 3 / 4 " to maximize its
operating life.
If the PTO shaft is too long
it can cause damage to the
!
chipper's bearings or
the tractor's power take-
off shaft when using the
3-point hitch when cutting.