Maintenance; Lubrication; Clutch Adjustment - Farmi Forest Corporation 351P Operation, Maintenance And Spare Parts Manual

MAINTENANCE

SAFETY
Disengage the P.T.O and turn the
tractor off before you service the
!
winch, remove the keys so the
tractor cannot be started up acci-
dentally.
DANGER!

LUBRICATION

Do not oil the drive chain, becau-
se the oil will work its way to the
!
clutch!
CAUTION!
The cable drum, main sprocket and snatchblock are
fitted with self lubricating bearings.
Following points require lubrication:
1. Grease the drum clutch parts after every 500
working hours. Always use good quality lubricati-
on grease.
2. Grease the PTO-shaft regularly and aways before
use as shown in figure 15.
3. Grease the drum chain lightly (not with oil) after eve-
ry 50 working hours with spray type, hardening
chain grease. Wipe off the excessive grease.
Swing joints sideways for greasing
8h
When used in winter
the guard tubes must
be greased to avoid
freezing.
Fig. 15. P.T.O shaft lubrication
FARMI 351P
8h
20h
Apply grease inside the
outer telescopic profile
h= working hours

CLUTCH ADJUSTMENT

1. Loosen the nuts A and B at both ends of the drum
axle. Wrench opening 1 7/16" (36 mm).
2. Adjust the clutch by turning the axle C with 9/16"
or 14 mm wrench. The clutch tightens clockwise,
loosens counterclockwise. Turn max. 1/4 turn.
3. After adjustment retighten the nuts A and B on
the ends of the drum axle.
4. Pull the control rope. The lever should move up
1.5" (4 cm) before the clutch engages. If the clutch
engages earlier loosen the clutch setting.
A
Fig. 16. Clutch adjustment
21
B C