Mounting - Farmi Forest Corporation 351P Operation, Maintenance And Spare Parts Manual

MOUNTING

MOUNTING TO THE 3-POINT HITCH
The winch can be mounted to the 3-point linkage of
any tractor. Power transmission is obtained through
universal shaft from tractor.
ASSEMBLY OF THE PTO SHAFT
If the PTO shaft is too long it may
get pressed when the three point
!
hitch is lifted up. This may cause
damage to the bearings of the
winch or to the PTO of the trac-
CAUTION!
tor. The PTO shaft must not be
too short in any position.
The PTO length is suitable, if the pipes do not reach
the bottom.
PTO is optional equipment.
1. Mount the winch to the 3-point hitch of the
tractor.
2. Raise the winch high enough to get the PTO shaft
of the tractor and the winch to a horizontal level.
3. If you have a shortened PTO shaft available, put
one end into the drive shaft and check that the
distance of the locking of the other end. Take into
account the additional clearance of approx. 20
mm (0.78").
4. Fasten the other end of the PTO shaft in its place
and also move the winch sideways at the same
time securing that the axis does not base.
FARMI 351P
SHORTEN THE DRIVE SHAFT
!
CAUTION!
Fig. 1. Measure A when the drive shafts are nearest to
each other.
Fig. 2. Shorten the drive shaft
• First cut the thicker cover to a correct lenght (1).
Remember 20 mm (0.78") clearance. Then cut
away the same amount from the form pipe. Make
a similar shortening to the second half of the PTO
shaft. Remove the burr with the file.
• Connect the PTO shafts within each other.
Make sure by moving eevator carefully up and
down that the shortening of the axis is sufficient.
Check that the axis have 20 mm (0.78") latitude.
15
Both PTO halves must be shorte-
ned by equal amounts.
A
20
A
2
1