Configuring Cluster Parameters - H3C S7500 Series Operation Manual

Operation Manual – Cluster
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Enable the cluster
function globally

1.2.7 Configuring Cluster Parameters

I. Creating a cluster and configuring cluster parameters manually
Follow these steps to configure cluster parameters manually:
Enter system view
Enter VLAN interface view
Configure the IP address
of the VLAN interface
Enter cluster view
Configure an IP address
pool for the cluster
Build a cluster
Configure the holdtime for
a switch
Set the interval to send
handshake packets
Quit cluster view
Use the command...
system-view
cluster enable
To do...
system-view
interface Vlan-interface
vlan-id
ip address ip-address
{ mask | mask-length }
cluster
ip-pool
administrator-ip-address
{ ip-mask |
ip-mask-length }
build name
holdtime seconds
timer interval
quit
—
Optional
By default, the cluster function is
enabled
Use the command...
1-9
Chapter 1 Cluster
Remarks
Remarks
—
Required
You are required to
configure the IP address
of the Layer 3 virtual
interface of VLAN 1
before you set up a
cluster. Otherwise, the
cluster cannot be set up.
Required
—
Required
Optional
The name argument
indicates the name to be
assigned.
Optional
By default, the holdtime is
60 seconds
Optional
By default, the interval to
send handshake packets
is 10 seconds
—