H3C S7500 Series Operation Manual page 15

Operation Manual – Cluster
H3C S7500 Series Ethernet Switches
The S7500 switch manages other two member devices as the management device.
The detailed information about the cluster is as follows.
The two member devices are connected to GigabitEthernet 2/0/2 and
GigabitEthernet 2/0/3 of the management device.
The management device is connected to the external network through
GigabitEthernet 2/0/1.
GigabitEthernet 2/0/1 belongs to VLAN 1, whose interface IP address is
163.172.55.1.
All the devices in the cluster use the same FTP server and TFTP server.
The FTP server and TFTP server share one IP address: 63.172.55.1.
The SNMP site and log host share one IP address: 69.172.55.4.
II. Network diagram
FTP/TFTP Server
63. 172.55.1
集群
Figure 1-3 Network diagram for HGMP cluster configuratio
III. Configuration procedure
1) Configure the member devices (taking one member as an example)
# Enable NDP globally and for Ethernet 1/1.
<H3C> system-view
[H3C] ndp enable
[H3C] interface Ethernet 1/1
[H3C-Ethernet1/1] ndp enable
[H3C-Ethernet1/1] quit
# Enable NTDP globally and for Ethernet 1/1.
Internet
Management
device
GE2 / 0/3
Eth1/ 1
MAC address of the
member device
MAC : 000f.e 201. 0011
SNMP/loggi
GE2/0/1
69. 172.55.4
IP address of
VLAN-interface 2
163. 172.55.1
GE2/0/2
Eth1/1
MAC address of the
member device
MAC: 000f.e 201. 0012
1-14
Chapter 1 Cluster
ng host( NMS)
n