Setting The Adsl Configuration - Alcatel Speed Touch PC Installation Manual

Setting the Configuration
1.
After your PC has rebooted, right-click
on the Mapi Icon, and select the
Configuration option.
2.
The Configuration window appears.
This is the Network Protocol and PVC
settings section. Enter in the VPI, VCI,
and Framing values supplied by your
ADSL service provider.
3.
In the Select ADSL Mode section,
select the mode(s) recommended by
your ADSL service provider. Click on
the mode(s) required and then click on
Settings.
NOTE: The service mode type will be one
of the following:
?
ANSI T1.413 Issue 2
?
ITU G.992.2 Annex A (G.lite)
?
ITU G.992.1 Annex (G.dmt)
4.
The PVC Setup window appears. Click
Yes to restart your PC system and to
allow the new changes to take effect.
5.
You must now make an ADSL
connection. Proceed to the section for
RFC1483
RFC2364
Alcatel Speed Touch PC
Bridged Ethernet over ATM
Point-to-Point Protocol over ATM
RFC 1483
RFC 2364
ð
Go to page 16
ð
Go to page 19
19