Erasing An Index Signal - Sony CCD-TRV95 Operating Instructions (primary manual) Operating Instructions Manual

Locating the marking position

Erasing an index signal

(1) Locate the index signal to be erased using the index scan or index search
function.
(2) Press ERASE on the Remote Commander within 2 to 10 seconds while the
desired program plays back. After the index signal is erased, the camcorder
returns to index scan when you used index scan in step 1. When you used
index search, normal playback resumes.
1
REW
INDEX
Notes on erasing
•Press ERASE more than 2 seconds after the playback of the desired program begins.
•You cannot erase the index signal on a tape with the red mark on the cassette exposed.
•While the index signal is being erased, the sound cannot be heard and a black band
appears at the bottom of the picture. This will not affect the recorded sound or picture.
•The camcorder can detect index signals marked with VCRs, but may not erase them.
VCRs with an index function can detect index signals marked with this camcorder but
may not erase them.
•An index signal may be erased when making PCM after recording on another VCR in
the portion where the index signal is marked.
Note on Data Code
When an index signal is erased, the Data Code on the same portion of the tape is also
erased.
FF
2
ERASE
75