Of A Recorded Tape (Ccd-Trv99 Only); Re-Recording A Picture In The Middle Of A Recorded Tape (Ccd-Trv99 Only) - Sony CCD-TRV95 Operating Instructions (primary manual) Operating Instructions Manual

Re-recording a picture in the middle of a
recorded tape
– CCD-TRV99 only
You can insert a scene in the middle of a recorded tape by setting the starting and
ending points. The previous recorded portion will be erased. When the RC time code
appears, set COUNTER to NORMAL in the menu system to display the tape counter.
(1) While the camcorder is in Standby mode, keep pressing the + (forward
playback) or – (reverse playback) side of EDITSEARCH, and release the button
where you want to end the insertion [b]. The camcorder enters Standby mode
again.
(2) Press COUNTER RESET. The counter resets to zero.
(3) Keep pressing the – side of EDITSEARCH and release the button at the point
where you want to start the insertion [a].
(4) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes.
(5) Press START/STOP to start recording. The recording stops automatically at
the counter zero point.
[a]
1
EDITSEARCH
4
ZERO MEM
STBY –0:01:23
ZERO MEM
To change the end point
Press ZERO MEM to erase the ZERO MEM indicator, then repeat steps 2 to 5.
62
[b]
3
EDITSEARCH
2
COUNTER
RESET
5
START/STOP
STBY 0:00:00
–0:01:22
ZERO MEM