6．Data Access; 7．Alarm Settings - ETCR ETCR2000+ Manual

6．Data Access
Press MEM key to enter Data Access Model, the default
display stored in the first 01 Units
of data, shown in Figure 11. Then
the right arrow keys, up, read the
data stored, press the left arrow key,
scroll down to the data stored. If not store data, display shown in
Figure 12.
In setting Alarm Critical Value state, need to press the POWER
key or press the AL key for 3 seconds, exit Alarm Critical Value
state, then press MEM key to enter data storage model.
7．Alarm Settings
In the test model, press AL key to turn on or shutdown alarm
function.
In test model, press AL key for 3 seconds, then enter to set
alarm critical value function, temporality, the highest-digit flashing,
first set a maximum bit, shown in Figure 13, Figure 14. Press AL
key to switch to the low number, in the current digit flashing, press
the left/right arrow keys to change the "0,1, ... 9" figures, after the
number finished setting, press the AL key for 3 seconds to confirm
the current set alarm critical value, when set the alarm function
successful, opening alarm function, then automatically return to
measurement mode. If the load bigger than the alarm critical,
meter will be flashing an
-16-