Panasonic CS-ME7CB1P Service Manual page 50

CS-ME7CB1P / CS-ME10CB1P / CS-ME12CB1P / CS-ME14CB1P / CS-ME10CD3P / CS-ME14CD3P
Troubleshooting
The following symptoms are not faults. Please continue to use it without fear.
Is it faulty?
There is noise.
For details about items not covered here, read the operating instructions attached at the outdoor uint for model
CS-ME7CKPG.
The TIMER lamp blinks
Cassette Type
How to self diagnosis
1
Press
3 alphanumeric digits will appear on the remote control display.
When the indoor unit gives off a continuous
2
"Beep, Beep, Beep, Beep" sound, slowly and
repeatedly press
H
F
When H33, H36 and H37 are displayed, you must not
operate until repairs have been done.
Press
operate the Heating • Cooling • Dry • Air circulation modes. (There will
be "Beep, Beep, Beep, Beep" sound to confirm the command is
received).
Sound of flowing water:
• Caused by the flow of refrigerant gas through the air conditioner system.
• Caused by the flow of condensated water by drain pump.
Is it okay?
Receiver unit
POWER
POWER
TIMER
ODOUR WASH
for 5 seconds
Inform your dealer on the displayed 3 alphanumeric digits.
DISPLAYED ALPHANUMERIC DIGITS
The H and F (followed by 2 numerals)
represent different sets of abnormalities.
H36 : Heating • Air circulation
H37 : Cooling • Dry • Air circulation
for 5 seconds, using the remote control select and
No, it is okay
Self diagnosis
Notify them of all abnormalities.
You can self diagnose using the remote
Duct Type
control. Follow the instructions below. After
confirmation, stop all operations and switch
off the power supply.
AUTO
OFF/ON
ODOUR
TIMER WASH
50
Consult your dealer
POWER
TIMER
ODOUR WASH
"Beep, Beep,
Beep, Beep"