Panasonic CS-ME7CB1P Service Manual page 38

Securing the Hanging Bolts
Reinforced concrete Wooden or other structure
(Unit: mm)
(Unit: mm)
Hanging
Insert hole-in
bolt M10
anchor, etc.
Hanging bolt
Ceiling surface
Switching the high state switch
(SW2)
Hanging
bolt M10
• To increase the air volume, open the
control box and on the control board
switch the high state switch (SW2) to
"HI".
• See the diagram for "Connecting the
Indoor/ Outdoor Connecting Cable".
Installation in the Ceiling
• Attach the nuts and washers to the hanging bolts, then
lift up and hook the main unit onto the hanging fixtures.
• Check that the unit is level using a level or a vinyl hose
filled partially with water.
Level
40
t =2
30
C channel
Hanging fixture
Mounting the Receiver
• Select a ceiling or wall position that does not block reception for the mounting location. Note that
the receiver cord is 2.0 m.
• First hook the clamps 11 onto the receiver mount 10 as shown in the figure below, then
Reinforcing materials partially tighten the mounting screws 12 .
(60 to 90 mm square) • Fit the receiver 8 into the receiver mount 10 so that the locking hooks are firmly engaged.
• Fit the above mounts into the ceiling or wall opening, and tighten the screws 12 until the clamps
11 firmly clasp the ceiling or wall materials.
• Attach the receiver cover 9 so that the hooks on the inside are firmly hooked onto the receiver
mount 10 .
Roof beam
• Lead the receiver cord and connect it to the control box.
Ceiling surface
Mounting Section View
Clamp 11
Receiver
Hanging bolt (M10) cover 9
(Locally Purchased)
Receiver 8
Ceiling or wall
Flat washer
(Locally Purchased) (thickness 7 to 12 mm)
Hexagonal nut (M10)
(Locally Purchased)
Ceiling or
+5
103
0
wall opening
Receiver 8 Locking hook
Receiver
Clamp
11
mount 10
Receiver
mount 10
Mounting hole
Clamp mounting
in the case
screw
12 using wood screw
(Locally Purchased)
Removal groove
Receiver cover 9