Table of Contents
Advertisement
If using a Static IP follow these steps
Step 1
Browse the Settings Page
Step 2
Click button marked Enter Manual IP Address (Even for DHCP)
Step 3
Ask your network administrator what IP address to use and what IP mask to use.
Step 4
Insert the values given by the network administrator into the text boxes on the page.
You don't need to worry about the Gateway and the DNS address, just leave them blank.
Step 5
Make sure the format has the full stops and double check they are correct.
Write down this address.
Step 6
Press the button marked Set.
Step 7
Connect LWS and your PC to the network using the Blue (straight through) network cables.
Step 8
Turn off LWS and wait a few seconds and then turn it back on.
Step 9
Get the network administrator to put your PC back on to the network.
Step 10
Browse to the address that you assigned to the LWS.
Add this page to your favourites or bookmarks, so that other users can find it easily.
General Browser Settings
Whether you are using Internet Explorer, Firefox, Safari or Chrome as your browser there are a couple
of settings that your browser needs to communicate successfully with the LWS. Javascript must be
turned on for this website. The character encoding should be UTF-8 or Auto-Detect.
These settings are generally turned on anyway so generally you don't have to change anything here.
Page 47
Document 36 II LWS-MKIII, pub V5 © Copyright 2012 LPI
Advertisement
Table of Contents
