Table of Contents
Advertisement
How to put LWS onto a Network
To put the LWS on a Local Area Network (LAN) you will need some help from the Network
Administrator.
You will need to know whether the Administrator wants you to use a fixed IP address or use DHCP to
assign your network settings.
The easiest way to do this is use an IP setup tool that can be provided by LPI. Ask us and we can
email it to you. Otherwise follow the steps below.
Initially
Establish communications with the LWS, by following directions in the section named "Establishing a
LAN Connection to the LWS Console".
If using DHCP follow these steps
Step 1
Browse the Settings Page
Step 2
Click button marked Enter Manual IP Address (Even for DHCP)
Step 3
Click button marked Automatic
Step 4
Connect LWS and your PC to the network using the Blue (straight through) network cables.
Step 5
Turn off LWS and wait a few seconds and then turn it back on.
Step 6
Get the network administrator to put your PC back on to the network.
Step 7
Ask your network administrator what address the LWS has been assigned and then browse to it.
Add this page to your favourites or bookmarks, so that other users can find it easily.
Page 45
Document 36 II LWS-MKIII, pub V5 © Copyright 2012 LPI
Advertisement
Table of Contents
