Install The Four-Post Rack Kit On A Pa-5200 Series Firewall - PaloAlto Networks PA-5200 Series Hardware Reference Manual

Install the Four-Post Rack Kit on a PA-5200
Series Firewall
The following procedure describes how to install the optional four-post rack kit (PAN-PA-5200-RACK4) to
provide additional support to the back of the firewall. This kit supports rack depths from 23 to 32 inches
(measured between the inner-parts of the vertical rails).
Attach one rack-mount bracket to each side of the firewall in the front-mount position using
STEP 1 |
nine #8-32 x 5/16" screws for each bracket and torque to 15 in-lbs.
STEP 2 | Attach one rack-mount rail to each side of the firewall using four #8-32 x 5/16" screws for
each bracket and torque to 15 in-lbs. The side brackets are universal but you must install them
with the beveled edge facing the firewall.
STEP 3 | With help from two other people, hold the firewall in the rack and secure the rack-mount
brackets to the front rack posts using four screws for each bracket. Use the appropriate screws
(#10-32 x 3/4" or #12-24 x 1/2") for your rack and torque to 25 in-lbs. Use cage nuts (not
provided) to secure the screws if the rack has square holes.
22
PA-5200 SERIES NEXT-GEN FIREWALL HARDWARE REFERENCE | Install the PA-5200 Series Firewall in
an Equipment Rack
2019 Palo Alto Networks, Inc.
©