Orion Standard Notes - Savaria ORION Planning Manual

Limited use/limited application elevator

Hide thumbs Also See for ORION:

Owner's manual (16 pages)

Table Of Contents

Table of Contents

The hoistway must be designed and built in accordance with the "Safety Code for Elevators and Escalators"

(ASME A17.1) and all state and local codes.

Due to close running clearances, the owner/agent must ensure that the hoistway and pit (where provided) are

level, plumb and square and are in accordance with the dimensions on these drawings.

Owner/agent must ensure the minimum overhead clearance is in compliance with codes.

Owner/agent to provide all masonry, carpentry and drywall work as required and shall patch and make good

(including ﬁ nish painting) all areas where walls/ﬂ oors may need to be cut, drilled or altered in any way to

permit the proper installation of the lift.

Contractor/customer to verify all dimensions and report any discrepancies to our ofﬁ ce immediately.

Structural engineer to assure that the building and shaft will safely support all loads imposed by the lift

equipment. Refer to the tables on the installation drawings for loads imposed by the equipment.

Suitable lintels must be provided by the owner/agent. Door frames are not designed to support overhead wall

loads.

Power supply with a lockable fused disconnect and auxiliary contact to brake the battery feed, or circuit

breakers with a 3-pole breaker for battery feed required in compliance with electrical code (contact your

Savaria dealer or refer to the table below for OEM part numbers).

Disconnect Switch Types & Accessories

2 Pole Solid Neutral 240V 1 PH

Required Auxiliary Contact

Required Type "D" Fuse (Buss type "FRN" or equal)

3 Pole Solid Neutral 208V 3 PH

Required Auxiliary Contact

Required Type "D" Fuse (Buss type "FRN" or equal)

1 Pole Solid Neutral 120V 1 PH

Required Type "D" Fuse (Buss type "T" or equal)

Permanent power of 240V single-phase 40 Amp or 208V three-phase 30 Amp must be supplied by others

before installation.

Remote hall call (when supplied) to be installed by the owner/agent at 42" from the landing ﬂ oor.

Entrance assemblies must be adjusted to align with the platform and interlock equipment. Others to allow an

adequate rough opening.

Entrance assembly must be securely fastened to walls by the elevator contractor.

Part No. 000682 15-m10-2015