Table of Contents
Advertisement
Log Settings
Click Log on the left side of the browser window, and then click the Log Settings tab.
Configure the following settings:
1. Mail Server - To e-mail log or alert messages, enter the name or IP address of your mail server
in the Mail Server field. If this field is left blank, log and alert messages are not
e-mailed.
2. Send Log To - Enter your full e-mail address(username@mydomain.com) in the Send log to field
to receive the event log via e-mail. Once sent, the log is cleared from the SonicWALL memory. If
this field is left blank, the log is not e-mailed.
3. Send Alerts To - Enter your full e-mail address (username@mydomain.com) in the Send alerts
to field to be immediately e-mailed when attacks or system errors occur. Enter a standard e-mail
address or an e-mail paging service. If this field is left blank, e-mail alert messages are not sent.
4. Firewall Name - The Firewall Name appears in the subject of e-mails sent by the SonicWALL. The
Firewall Name is helpful if you are managing multiple SonicWALLs because it specifies the
individual SonicWALL sending a log or an alert e-mail. By default, the Firewall Name is set to the
SonicWALL serial number.
Logging and Alerts Page 93
Advertisement
Table of Contents
