Sonicwall Tele3 Sp - SonicWALL Internet Security Appliances Administrator's Manual

SonicWALL TELE3 SP Front Panel
The SonicWALL TELE3 SP front panel is shown below, followed by a description of each item.
Modem LED
Power LED
SonicWALL TELE3 SP Front Panel Description
• Power
Lights up when power is applied to the SonicWALL TELE3 SP.
• Modem
Lights up when the modem has established a dial-up connection.
There is are two Ethernet ports for the LAN and WAN connections:
• Link
Lights up when the Twisted Pair port is connected to a 10Mbps or 100Mbps hub or switch, or
directly connected to a computer. Note that the connected Ethernet device must support the
standard Link Integrity test.
• 100
Lights up when the Twisted Pair port is connected to a 100Mbps hub or switch or directly
connected to a computer with a 100Mbps network interface.
• Activity
Flashes when the SonicWALLTELE3 SP transmits or receives a packet through the Twisted Pair
port.
• Test
Lights up when the SonicWALL TELE3 SP is first powered up and performing diagnostic tests to
check for proper operation. These tests take about 90 seconds. If the Test LED remains lit after
this time, the software is corrupt and must be reinstalled.
WAN Port LEDs LAN Port LEDs
Link, 100, Activity Link, 100, Activity
Test LED
Hardware Descriptions Page 243